Media
Navigation
Media comments
-
A1975 o'day 22will be changing to led lights both mast and cabin along with nav lights. adding solar, adding bbq, rebedding all deck hardware and below water...
-
-
MacGregor 26sDas sind Teakleisten, die aufgeklebt, dann mit Schwarzer Masse ausgegossen und geschliffen wurden. Sieht immer noch aus wie neu.....
-
-
Media statistics
- Albums
- 3,799
- Uploaded media
- 22,708
- Embedded media
- 19
- Comments
- 425
- Disk usage
- 2.2 GB
Aluminum plates 3/16" x 11-1/4" wide (at the bottom) x 18" high, cut with an electric hand jig saw in about 20 minutes. Used cut off material to make bracket for push down rod. A bolt in lower section holds a steel cable running back between plates up through pintle brackets (changed to 1/4" line above water line) to pulley under tiller, forward to self releasing clam cleat also under side of tiller.
- jenquay
- Sep 21, 2013
- 0
- 0
I added two pieces of aluminum 29" long to each side of the tiller (extending 17" aft of the rudder). They are ground to a very snug fit into the brackets holding the tiller to the rudder. A line runs from the push down rod bracket upwards between 2 bolts with PVC spacers at the end of the aluminum, forward to a small cleat on the tiller. To raise the rudder, simply lift the tiller handle, pull the line taught & hold it over the cleat, push down tiller handle and the rudder pops right up. Also the system holds the rudder up while traveling.
- jenquay
- Sep 21, 2013
- 0
- 0
