Media
Navigation
Media comments
-
A1975 o'day 22will be changing to led lights both mast and cabin along with nav lights. adding solar, adding bbq, rebedding all deck hardware and below water...
-
-
MacGregor 26sDas sind Teakleisten, die aufgeklebt, dann mit Schwarzer Masse ausgegossen und geschliffen wurden. Sieht immer noch aus wie neu.....
-
-
Media statistics
- Albums
- 3,799
- Uploaded media
- 22,708
- Embedded media
- 19
- Comments
- 425
- Disk usage
- 2.2 GB
Learning some new skills, this is 5/16" VPC double strand... learned how to eye splice using NERs demo video... these ronstan snap shackles are for the spin halyard and genoa halyard, they need to be spliced on... learning to do this saved me not only the cost of paying someone else to splice these, but also the cost of a shackle! Since I had good ones already!
- shnool
- May 6, 2015
- 0
- 0
This is the new name, yep we'll have a ritual for launch... cause this boat has had an extensive refit, it seemed appropriate to rechristen her... nope I didn't spell anything wrong... Was thinking of getting company logos for Goslings, Pussers, Mount Gay, Krakken, Pyrat, and lining them up below that name.
- shnool
- May 6, 2015
- 0
- 0
Routing the wind transducer wire... I used micro C through deck connectors, and spliced the simnet cables.. we'll see if it worked. The wiring inside a simnet cable is identical to NMEA 2000, the connectors are just different.. I just needed a solution to allow me to disconnect the transducer for trailering.
- shnool
- May 6, 2015
- 0
- 0
Spreaders welded... note, the spreaders are "sealed" on the S2, if you leave the mast on the boat horizontal for the winter, rainwater drains down from the mast side into the spreaders, then freeze/thaw cycles bust the seams of the spreaders... best to drill a weep hole near the end (done later in this project after painting)>
- shnool
- May 6, 2015
- 0
- 0
