stanchion

  1. V

    Hunter 356 stanchion

    Hello I have searched older post but can not find an answer to my problem. I have a leak that is either a rubrail issue or the port stanchion gate. I went to remove the stanchion and I have one screw that is spinning. I can see down the other hole, I don’t see or feel an aluminum backing plate...
  2. Maurice Doran

    Looking for info - how to access stanchion base on 2005 H33

    I noticed the flat stanchion base in which the stanchion sits is a bit wobbly and there are what looks like stress cracks around it. It's been there since I bought the boat and I suspect someone has tried to push the boat off while grabbing the stanchion. It's located on the starboard side, and...
  3. A

    Lifeline Stanchions for Hunter 37.5 Legend

    Hello - I am desperately searching for lifeline stanchions for our Hunter 37.5 Legend. Hunterowners shop won't have any in stock until August 7. I need them ASAP! I've searched marine salvage yards online - no luck. These stanchions were used on Hunters from the late 80s through the late...
  4. Good Vibes

    Accessing forward throughbolts for stanchion rebedding

    Good day. I am new to the forum. My wife and I have just bought a 310 and need to rebed the forward stanchions abeam the Vberth windows. Can anyone shed light on how to access the throughbolts without cutting into the liner? Thanks!
  5. jorg027

    Stanchion grommet/sleeve

    On our 23, the eyelets of the stanchions seem to be missing a protective grommet or sleeve. Where the lifelines run through the hole, they show considerable wear- almost down to the stainless wire. Any suggestions to solve this problem? Thanks!
  6. Dutchman

    Serious Repair Question

    So I spent the other day at a steady 30-45 degree angle with a big 155 and full main spread. Very fun and lost rudder effectiveness on a few occasions but this was the unwelcome result. Port side stay anchor on my Hunter 25.5. Outside deck has a slight cracking that doesn't look to bad but...
  7. JamesG161

    Stanchion Bolt Removal

    I have traced a slight leak to the support stanchions that are the gate way supports (4) on both sides of my boat. I need to remove or loosen and reseal these 16 Stainless Steel though bolts. Hunter did a thoughtful job of providing access, albeit very tight, to them. The access reveals on the...