Media
Navigation
Media comments
-
Finished!Those replacement bulkheads look great and appear to match well to the other woodwork I can see in the photos. I'll try to figure out how to... -
SERENITYYou can use both panels at the same time. Because they are completely seperate sytems. The only reason you have a master over ride switch on you... -
SERENITYI am replacing the original panel all together. The original panel is not waterproof and is down by the floor. I'm also adding circuits. The...
-
SERENITYYes, you can have the DC panel & the AC panel active at the same time. They are electricity seperate systems.
-
SERENITYAnd you don't have an override like on a house generator breaker, you just make sure all switches except your master/battery switch are off while...
Media statistics
- Albums
- 3,799
- Uploaded media
- 22,708
- Embedded media
- 19
- Comments
- 425
- Disk usage
- 2.2 GB
Aluminum plates 3/16" x 11-1/4" wide (at the bottom) x 18" high, cut with an electric hand jig saw in about 20 minutes. Used cut off material to make bracket for push down rod. A bolt in lower section holds a steel cable running back between plates up through pintle brackets (changed to 1/4" line above water line) to pulley under tiller, forward to self releasing clam cleat also under side of tiller.
- jenquay
- Sep 21, 2013
- 0
- 0
I added two pieces of aluminum 29" long to each side of the tiller (extending 17" aft of the rudder). They are ground to a very snug fit into the brackets holding the tiller to the rudder. A line runs from the push down rod bracket upwards between 2 bolts with PVC spacers at the end of the aluminum, forward to a small cleat on the tiller. To raise the rudder, simply lift the tiller handle, pull the line taught & hold it over the cleat, push down tiller handle and the rudder pops right up. Also the system holds the rudder up while traveling.
- jenquay
- Sep 21, 2013
- 0
- 0
All around I did peel off the the vinyl liner from the overhead liner, as I had to clean out all the mouse detritus. But I also cut access for the stanchion bolts/nuts, as well as wiring at various points. I cut luan plywood to fit the curves and attached with white nylon bolts, machine thread, tapped into the overhead glass. It is now easy to access wiring or stanchion blots.
- Golden Road
- Sep 16, 2013
- 0
- 0
