All Activity
-
FastOlson reacted to Ralph Johnstone's post in the thread Fwd Gear not always engaging- reverse fine with
Like.
Am I correct in assuming the X-mission output flange also spins with the prop shaft and the X-mission is in neutral ? "Why all the... -
Pacific Area, follows Hurricane Lala. Aloha Jim... -
-
Ccolemj replied to the thread Terminal connectors.The heat shrink provides a nice transition support for the wire/terminal interface. Mark
-
Joe replied to the thread Adjustable back stay and the over crowded cleat.Apex and Stu make logical points. Since it is a stay, it should be attached to the boat with some type of chain plate. Think about it... -
njlarry replied to the thread Installing an in the hull transducer.I just bed mine in plumbers putty. Dries out every few seasons and easy to replace. G flex would be more permanent but make transducer... -
shemandr replied to the thread A few short Cat22 newbie questions.Downwind we used to set the main to full extension on downwind legs. It was what is called the full barn door mode. How does... -
If your boat is submerged in salt water for 36 days you'll probably have bigger issues to worry about than those electrical connectors. -
PaulK reacted to Project_Mayhem's post in the thread Fwd Gear not always engaging- reverse fine with Like.
I would start out by securing the cable a bit better. Also check to see if it engages if you remove the cable and shift the lever on the... -
Ralph Johnstone replied to the thread Fwd Gear not always engaging- reverse fine.What fluid is in the x-mission now and when was it last changed ? Did this problem occur in one fell swoop or has it been slowly... -
Tally Ho replied to the thread Fwd Gear not always engaging- reverse fine.I would have someone shift the tranny from N to F while you observe the transmission lever. The cable may be tight, but it could also... -
I just saw a pretty well done video on the AC 75 LaRoche-Posay, and I must say, it may be the ugliest sailboat I've ever seen. It was... -
Gene Neill replied to the thread A few short Cat22 newbie questions.Okay well I technically do have an outhaul, but it's only a 1:1 purchase, so I can't really change the sail shape with it. I have two... -
Have to disagree with the no boom vang comment. You can maintain a much better sail shape going downwind with one.
-
Gene Neill replied to the thread Rocna Anchor.Beautiful!
-
Gene Neill reacted to Captain Grey Beard's post in the thread Replacing mast-wiring connection with Like.
Actually the masthead light and the steaming light can share the same negative. So those 2 lights only require 3 wires. However, if...
