All Activity
-
Ralph Johnstone replied to the thread Installing an in the hull transducer.Gotcha. -
MMike Oldak replied to the thread Installing an in the hull transducer.My installation had about a 22 degree hull angle port to starboard and a 17 degree Fore to aft. While I never heard of that method but...
-
MMike Oldak replied to the thread Installing an in the hull transducer.The T79 transducer measures depth and provides a contour of the ground. Probably analyzes the sonar reflections. Look up axiom for...
-
Ralph Johnstone replied to the thread Fwd Gear not always engaging- reverse fine.Am I correct in assuming the X-mission output flange also spins with the prop shaft and the X-mission is in neutral ? "Why all the...
-
Ralph Johnstone replied to the thread Fwd Gear not always engaging- reverse fine.For the sake of clarity, does the output flange continue to spin once the prop shaft slows down. I can see, but need to hear it from you.
-
Ralph Johnstone reacted to Project_Mayhem's post in the thread Fwd Gear not always engaging- reverse fine with
Like.
I would start out by securing the cable a bit better. Also check to see if it engages if you remove the cable and shift the lever on the... -
Ccolemj replied to the thread Acrid smoke in engine compartment.He said it didn't occur with the engine out of gear, so probably not those.
-
Ralph Johnstone replied to the thread Installing an in the hull transducer.Quick question for you Hayden. Why go to all that trouble when the solid inter-layer method (silicone, etc.) is so simple and has no...
-
Hayden Watson replied to the thread Installing an in the hull transducer.I have been using the same Peak Sierra pet safe antifreeze in my transducer that I use in my engine and hydronic heater. I build a... -
-
Hayden Watson reacted to Mike Oldak's post in the thread Installing an in the hull transducer with Like.
I just made a circular dam and then filled it with rv antifreeze so no air bubbles below transducer. Structure just provided a round...
-
Ralph Johnstone replied to the thread Installing an in the hull transducer.Not clear here. Sonar are the transmitted sound waves which measure the depth. Can you please clarify what I'm missing when you say...
-
thinwater replied to the thread Threaded closing mushroom vent?.In my case, the inner knob and screen were removed, and it was used as a water heater exhaust vent. -
Ralph Johnstone replied to the thread Installing an in the hull transducer.I'm sure that using a carefully installed silicone base, you would have had the same readings but without the hassle and problems of...
-
kappykaplan replied to the thread Hunter 216 deck crack at chain plate.Lightnsail, this is a 10-yr old post! -
MMike Oldak replied to the thread Installing an in the hull transducer.I've install several in hull transducers and they all worked. Have both a sonar and depth reading thru the hull Both garmin and...
