All Activity
-
Ddlochner replied to the thread Connection of Main Sheet to Sole attachment point.At least for the Tanzer 22 there was a very active Class Association and newsletter full of tips. The glossy mags, Sail, Cruising World...
-
Ddlochner replied to the thread Engine compartment venting.Only if you don't want to blow up. :biggrin:
-
BigEasy replied to the thread Stern light Q’s.Mine is located off center on transom, low enough that it doesn’t cast any light into cockpit. I once had a an aluminum run about that... -
There was a guy at the Indiantown Marina FL who did the water bags for yachts transiting the Okeechobee waterway. I've heard he died...
-
Tow it - 28' is not big enough for davits. Can always put on the foredeck if you need to get it out of the water.
-
fred1diver replied to the thread Head sink hose replacement recommendations.Thank you -
fred1diver reacted to BigEasy's post in the thread Head sink hose replacement recommendations with
Like.
I recently replaced the 1 1/2” galley & lavoratory drain hoses with Raritan saniflex hose. The OEM hoses that I replaced were 20 year... -
BigEasy replied to the thread Head sink hose replacement recommendations.I recently replaced the 1 1/2” galley & lavoratory drain hoses with Raritan saniflex hose. The OEM hoses that I replaced were 20 year...
-
Hello all! we are working on replacing the head countertop, wood and laminate, after looking at the drain hose it appears to be very...
-
shemandr replied to the thread Hunter 356 stern access.I think mine had sliding bolts and pretty flimsy at that. The whole panel is, in my mind, decorative. It is not a bulkhead. -
shemandr replied to the thread How to find a Catalina 250 wing keel trailer?.A good used boat trailer custom for a specific boat will be hard to find. I would look into a new custom trailer. Yes, it's expensive...
-
Ddanm1 replied to the thread Hunter 356 stern access.Do you recall if it's just the two barrel bolts? When I lift and pull it goes up a bit, but the bottom won't come forward. Thanks.
-
That might be concerning on a cheaper boat, but Peason was known to build solid boats so perhaps the whole transom has a lot of layers...
-
FastOlson replied to the thread Stern light Q’s.That might be concerning on a cheaper boat, but Peason was known to build solid boats so perhaps the whole transom has a lot of layers... -
fred1diver replied to the thread Engine compartment venting.Very good point, thank you for pointing that out, it will be taken into consideration .