Hi, I was wondering if anyone could measure how far out the top and bottom of their outboard wedge sticks out? Trying to figure out the correct angle. It's a bit difficult to determine when I'm unsure if any surface of the boat is actually level
That's a fantastic idea! Who woulda thought that not power washing at haul out would have an advantage? Thank you!So the boat is out of the water and you would like to have it sitting like it’s in the water? Measure down from the dirty water line at the bow and make it equal to the dirty water mark in the stern.
Thank you very much for the dimensions! I'm going to cut out a wooden wedge to put between the metal mount and the wood that the motor clamps to. Welcome to the forums!i just got to measure my wedge . it is on starboard side. upper starboard is 5-3/4", upper port side is 3-1/2", lower starboard side is 3" and lower port side is 5/8 " . the wedge is 12 " tall and 11-1/4 wide. mine was rotting so i used it as a pattern. the side that fits against the transom is not flat but curves to match boat transom which takes the most time to sand out a little at a time to get the right fit. hope this might be of some help. induvial results will vary . happy sailing