Hunter 376 stanchions
- Thread starter Velella
- Start date
These threads should provide the answer:
Stanchion Bolt Removal
I have traced a slight leak to the support stanchions that are the gate way supports (4) on both sides of my boat. I need to remove or loosen and reseal these 16 Stainless Steel though bolts. Hunter did a thoughtful job of providing access, albeit very tight, to them. The access reveals on the...
forums.sailboatowners.com
Loose stanchions
While prepping the boat for spring launch I noticed that two of the port stanchions are loose, not flopping around but not tight against the deck either. I would rather not deal with water leaks in the new boat. They are not attached from the top with machine screws through-bolted, before I...
forums.sailboatowners.com
Where are the stanchion bolt nuts?????
I need to repair the gunwale, starboard side, just forward of the "gate" stanchion. Yesterday I was attempting to remove the stanchion. In the cabin under this stanchion is the electrical panel. It will be extremely difficult to remove the primary stanchion nut as it is. When I looked for...
forums.sailboatowners.com
This has been resolved. There are four to five bolts that hold down each of the stanchions on our 1996 376. All bolts go into a plate imbedded in the fibreglass. You can simply unscrew them. I say simply if you are lucky and they are not ceased.