New-to-me 2006 Hunter 38 with a Furlex 200s. If there is any tension on the jib halyard, I get halyard wrap while furling up the jib and cannot furl the jib up completely. See photos below. When all tension on the halyard is released, the wrap resolves and I can completely furl up the jib. I figured this out through trial and error in some dicey conditions with the jib and sheets flailing around. Is this normal behavior? I have a Selden fractional rig and the halyard exits a sheave box which is the recommended configuration in the 200s manual. I have cleaned and lubed the upper swivel so that it spins smooth and freely. I had a Catalina 30 with CDI furling gear and this didn't happen. Any suggestions for troubleshooting appreciated.