Thoughts About Unmonitored Generator Operation
The concerns I would have about runing a gen set while sleeping is knowing about what could go wrong. Fortunately, on the newer boats, there is an alternative escape route so that helps.Electrical wiring, especially 110v, is subject to vibration and corrosion. The newer boats I suspect are using tin-plated wires but the older ones had just plain copper. The vibration, caused by the diesel engine, can cause the contacts between the receptacle and the conductor to loosen. I have pictures that were submitted some time back about what happens - the contacts heat up and start melting things. If not caught there can be a fire.Another concern is about air quality, or primarily the lack there of, from diesel exhaust. The scientific literature is replete with the hazardous aspects of diesel exhaust (for example, http://www.lungusa.org/air/airout00_diesel.html), and this is a compariatively mild report about the hazardous aspects of breathing this stuff. A Scientific American article a couple years ago had much stronger wording about diesel exhaust hazards. Unlike an RV where air can flow under the vehicle and where the occupants are above the ground, in a sailboat most occupants are closer to sea level and down low and there probably is poor air exchange with the outside.A third issue is what happens if something goes wrong with the generating system such as, say, a fuel leak? What about the fuel-return lines for a diesel gen set - do they have them? If so there is the potential for a runaway engine. Should something happen while everybody is sleeping this could cause serious problem.Houses have electrical work that is done by licensed electricians and inspected and they are not constantly vibrated - a big difference.Fortunately our waters are cooled by the melting Alaska glaciers and the polar ice cap so the weather isn't quite as hot as back east. The flip side of the coin, however, is you need a waterproof boat and a good heater!