Media
Navigation
Media comments
-
Finished!Those replacement bulkheads look great and appear to match well to the other woodwork I can see in the photos. I'll try to figure out how to... -
SERENITYYou can use both panels at the same time. Because they are completely seperate sytems. The only reason you have a master over ride switch on you... -
SERENITYI am replacing the original panel all together. The original panel is not waterproof and is down by the floor. I'm also adding circuits. The...
-
SERENITYYes, you can have the DC panel & the AC panel active at the same time. They are electricity seperate systems.
-
SERENITYAnd you don't have an override like on a house generator breaker, you just make sure all switches except your master/battery switch are off while...
Media statistics
- Albums
- 3,799
- Uploaded media
- 22,708
- Embedded media
- 19
- Comments
- 425
- Disk usage
- 2.2 GB
Gin pole made of an old spar and small winch and a couple of blocks. Allow single handed mast stepping operation. Unlike other systems the gin pole stays at a constant angle. A boom bail is installed on the mast to connect the line that goes to the winch. A nice guy at West marine explained this system to me. The extensible high crutch helps. Thus far, I have stepped the mast a 4 times single handed with no baby stays and I have not encountered major issues, e.g. routine minor untangling. I plan to add baby stays to make the system it bullet proof.
- stvnm
- Aug 26, 2015
- 0
- 0
