Media

Navigation

Browse albums

Media comments

  • ToddL214
    Finished!
    Those replacement bulkheads look great and appear to match well to the other woodwork I can see in the photos. I'll try to figure out how to...
  • Captain Grey Beard
    SERENITY
    You can use both panels at the same time. Because they are completely seperate sytems. The only reason you have a master over ride switch on you...
  • Captain Grey Beard
    SERENITY
    I am replacing the original panel all together. The original panel is not waterproof and is down by the floor. I'm also adding circuits. The...
  • Captain Grey Beard
    SERENITY
    Yes, you can have the DC panel & the AC panel active at the same time. They are electricity seperate systems.
  • hudson_rogue
    SERENITY
    And you don't have an override like on a house generator breaker, you just make sure all switches except your master/battery switch are off while...

Media statistics

Albums
3,799
Uploaded media
22,708
Embedded media
19
Comments
425
Disk usage
2.2 GB
A good case for finishing your teak. It is just too pretty this way as opposed to the "ignored gray" finish alot of people use. I used cetol "natural teak" as recommended by appleman.

A good case for finishing your teak. It is just too pretty this way as opposed to the "ignored gray" finish alot of people use. I used cetol "natural teak" as recommended by appleman.

  • 0
  • 0
I fashioned the floorboards from cherry. I used a lighter stain on them and used cetol because it is not slippery as polyurethane. I initially put sand on it, but sanded it off as i didn't like it. it does not seem slippery.

I fashioned the floorboards from cherry. I used a lighter stain on them and used cetol because it is not slippery as polyurethane. I initially put sand on it, but sanded it off as i didn't like it. it does not seem slippery.

  • 0
  • 0
refinished all teak, i used a cabbott "red mahogany" and cabbott polyurethane semigloss. I setteled on cabbott after trying a couple of other brands. I am glad i painted the bulkheads, they show off the teak.

refinished all teak, i used a cabbott "red mahogany" and cabbott polyurethane semigloss. I setteled on cabbott after trying a couple of other brands. I am glad i painted the bulkheads, they show off the teak.

  • 0
  • 0
I painted the areas i repaired with interlux brightside. the "grand banks beige" matched the non skid closely. You can see that i raised the area at the chainplate slighly to keep water from puddling around the plate.

I painted the areas i repaired with interlux brightside. the "grand banks beige" matched the non skid closely. You can see that i raised the area at the chainplate slighly to keep water from puddling around the plate.

  • 0
  • 0
Diving with Baracuda in Turks & Caicos

Diving with Baracuda in Turks & Caicos

  • 0
  • 0
Crossing the bay to New York

Crossing the bay to New York

  • 0
  • 0
Sitting on our mooring

Sitting on our mooring

  • 0
  • 0
My refurbished dinghy

My refurbished dinghy

  • 0
  • 0
The inside of our Oday

The inside of our Oday

  • 0
  • 0
Just dropped into engine compartment

Just dropped into engine compartment

  • 0
  • 0
Engine sitting on dock

Engine sitting on dock

  • 0
  • 0
We used the main boom to pick the engine up and drop it into the engine compartment

We used the main boom to pick the engine up and drop it into the engine compartment

  • 0
  • 0
IMG 0736

IMG 0736

  • 0
  • 0
IMG 0728

IMG 0728

  • 0
  • 0
Maxie 72 dpi #2

Maxie 72 dpi #2

  • 0
  • 0
Stbd tack 72 dpi

Stbd tack 72 dpi

  • 0
  • 0
Heading home under the Eggner's Ferry bridge on Kentucky Lake.

Heading home under the Eggner's Ferry bridge on Kentucky Lake.

  • 0
  • 0
H34 Stern

H34 Stern

  • 0
  • 0
H34 port close

H34 port close

  • 0
  • 0
H34 Starboard

H34 Starboard

  • 0
  • 0
Rogue under sail on Kentucky Lake

Rogue under sail on Kentucky Lake

  • 0
  • 0
DSC00843

DSC00843

  • 0
  • 0
Galley

Galley

  • 0
  • 0
A little polish and maybe some clear paint.

A little polish and maybe some clear paint.

  • 0
  • 0
Top Bottom