Media

Navigation

Browse albums

Media comments

Media statistics

Albums
3,799
Uploaded media
22,708
Embedded media
19
Comments
425
Disk usage
2.2 GB
After much experimentation with products and techniques, these are the final products used to finish. My Girl was moderately oxidized, meaning no shiney spots at all, but not as bad a a piece of chalk. To get a reflection, you MUST USE WET SANDPAPER. Trust me on this, you cannot get a gloss by just buffing, even buffing several times over and over again.

After much experimentation with products and techniques, these are the final products used to finish. My Girl was moderately oxidized, meaning no shiney spots at all, but not as bad a a piece of chalk. To get a reflection, you MUST USE WET SANDPAPER. Trust me on this, you cannot get a gloss by just buffing, even buffing several times over and over again.

  • 0
  • 0
A good case for finishing your teak. It is just too pretty this way as opposed to the "ignored gray" finish alot of people use. I used cetol "natural teak" as recommended by appleman.

A good case for finishing your teak. It is just too pretty this way as opposed to the "ignored gray" finish alot of people use. I used cetol "natural teak" as recommended by appleman.

  • 0
  • 0
I fashioned the floorboards from cherry. I used a lighter stain on them and used cetol because it is not slippery as polyurethane. I initially put sand on it, but sanded it off as i didn't like it. it does not seem slippery.

I fashioned the floorboards from cherry. I used a lighter stain on them and used cetol because it is not slippery as polyurethane. I initially put sand on it, but sanded it off as i didn't like it. it does not seem slippery.

  • 0
  • 0
refinished all teak, i used a cabbott "red mahogany" and cabbott polyurethane semigloss. I setteled on cabbott after trying a couple of other brands. I am glad i painted the bulkheads, they show off the teak.

refinished all teak, i used a cabbott "red mahogany" and cabbott polyurethane semigloss. I setteled on cabbott after trying a couple of other brands. I am glad i painted the bulkheads, they show off the teak.

  • 0
  • 0
I painted the areas i repaired with interlux brightside. the "grand banks beige" matched the non skid closely. You can see that i raised the area at the chainplate slighly to keep water from puddling around the plate.

I painted the areas i repaired with interlux brightside. the "grand banks beige" matched the non skid closely. You can see that i raised the area at the chainplate slighly to keep water from puddling around the plate.

  • 0
  • 0
Diving with Baracuda in Turks & Caicos

Diving with Baracuda in Turks & Caicos

  • 0
  • 0
Crossing the bay to New York

Crossing the bay to New York

  • 0
  • 0
Sitting on our mooring

Sitting on our mooring

  • 0
  • 0
My refurbished dinghy

My refurbished dinghy

  • 0
  • 0
The inside of our Oday

The inside of our Oday

  • 0
  • 0
Just dropped into engine compartment

Just dropped into engine compartment

  • 0
  • 0
Engine sitting on dock

Engine sitting on dock

  • 0
  • 0
We used the main boom to pick the engine up and drop it into the engine compartment

We used the main boom to pick the engine up and drop it into the engine compartment

  • 0
  • 0
IMG 0736

IMG 0736

  • 0
  • 0
IMG 0728

IMG 0728

  • 0
  • 0
Maxie 72 dpi #2

Maxie 72 dpi #2

  • 0
  • 0
Stbd tack 72 dpi

Stbd tack 72 dpi

  • 0
  • 0
Heading home under the Eggner's Ferry bridge on Kentucky Lake.

Heading home under the Eggner's Ferry bridge on Kentucky Lake.

  • 0
  • 0
H34 Stern

H34 Stern

  • 0
  • 0
H34 port close

H34 port close

  • 0
  • 0
H34 Starboard

H34 Starboard

  • 0
  • 0
Rogue under sail on Kentucky Lake

Rogue under sail on Kentucky Lake

  • 0
  • 0
DSC00843

DSC00843

  • 0
  • 0
Galley

Galley

  • 0
  • 0
Top Bottom