Media
Navigation
Media comments
-
Finished!Those replacement bulkheads look great and appear to match well to the other woodwork I can see in the photos. I'll try to figure out how to... -
SERENITYYou can use both panels at the same time. Because they are completely seperate sytems. The only reason you have a master over ride switch on you... -
SERENITYI am replacing the original panel all together. The original panel is not waterproof and is down by the floor. I'm also adding circuits. The...
-
SERENITYYes, you can have the DC panel & the AC panel active at the same time. They are electricity seperate systems.
-
SERENITYAnd you don't have an override like on a house generator breaker, you just make sure all switches except your master/battery switch are off while...
Media statistics
- Albums
- 3,799
- Uploaded media
- 22,708
- Embedded media
- 19
- Comments
- 425
- Disk usage
- 2.2 GB
Pulling the perkins: rear main seal, all new hoses and better type hose clamps, plumb in a rapid oil change fitting (flip a switch and the hot oil gets sucked out of the bottom of the engine), new oil pan gasket, pull the heat exchnager and clean, new motor isolators, re wire harnesses, rebuild starter, referb velvet drive, install new shaft and pyi dipless packing gland......wow what a 2 month project. this is my buddy that helps gotta love thos guys
- aduffE37
- Dec 28, 2010
- 0
- 0
red is coming off......subsequently brought the hul down to patent gelcoat and fixed blisters where they were....(not many) sealed in epoxy then five coats of interprotect and the addition of a wash down pum with new through hulls with counter sunk silicone bronse fasteners.
- aduffE37
- Dec 28, 2010
- 0
- 0
