Media
Navigation
Media comments
-
-
-
A1975 o'day 22will be changing to led lights both mast and cabin along with nav lights. adding solar, adding bbq, rebedding all deck hardware and below water...
-
Media statistics
- Albums
- 3,799
- Uploaded media
- 22,708
- Embedded media
- 19
- Comments
- 425
- Disk usage
- 2.2 GB
093 One of the fiberglass mat layers specified by Catalina. I believe they want 3 alternating layers of mat and roving material, but I recommend a fourth mat layer on top to leave a smoother finish. I also added some 6" wide 23oz 45deg biaxial cloth up the sides of the bilge. Removing two 3/4" plywood layers on our 1984 boat meant that I had to rebuild 1.5" back up. The fiberglass cloth and roving doesn't get all that. Plus, adding two 1/2" layers of G-10 like I did on top of the cloth makes a VERY substantial bearing surface for tightening down the keelbolts onto.
- rbmcintire
- Jan 14, 2013
- 0
- 0
IMG 1587 You should add West System Low Density Filler to the epoxy when installing the G10 boards. Press the board into place, the stuff googes up around the sides and fills in the gaps. Trowel or fillet it up neat and let it set. I covered the top layer G-10 pieces with blue tape so I could keep the top finish without blobs on the surface and ready for paint
- rbmcintire
- Jan 14, 2013
- 0
- 0
IMG 1581 After removing the wet plywood, then layering fiberglass mat and roving per Catalina's repair specifications, I then added two 1/2" layers of G-10 board. Used 1/2 blue foam for making templates and then cut the G-10 to match the shape and keelbolt hole positions. I staggered the two layers so the joints between pieces were never in the same location.
- rbmcintire
- Jan 14, 2013
- 0
- 0
014 Home-made gantry with come-along. Adult-size, erector set strut material is available at HD/Lowes. Bolt it up, protect the fiberglass deck and you're ready. The mast needs to taken off to do the compression post support repairs, so using the boom to lift the 325lb motor wasn't an option. After disconnecting wiring, shaft flange, exhaust and engine mounts, it was up on blocks, inside the boat, in 30 minutes. A one person job.
- rbmcintire
- Jan 14, 2013
- 0
- 0
Anchored at Bahia Honda State Park in the Florida Keys! That cockpit shade was really really nice to have in the hot sun down there. It made the cockpit a great place to chill out during the day. Next time though I will need to bring something to drape on one side for when the sun gets lower in the sky.
- sailingandsuch
- Jan 10, 2013
- 0
- 0
