Media

Navigation

Browse albums

Media comments

  • ToddL214
    Finished!
    Those replacement bulkheads look great and appear to match well to the other woodwork I can see in the photos. I'll try to figure out how to...
  • Captain Grey Beard
    SERENITY
    You can use both panels at the same time. Because they are completely seperate sytems. The only reason you have a master over ride switch on you...
  • Captain Grey Beard
    SERENITY
    I am replacing the original panel all together. The original panel is not waterproof and is down by the floor. I'm also adding circuits. The...
  • Captain Grey Beard
    SERENITY
    Yes, you can have the DC panel & the AC panel active at the same time. They are electricity seperate systems.
  • hudson_rogue
    SERENITY
    And you don't have an override like on a house generator breaker, you just make sure all switches except your master/battery switch are off while...

Media statistics

Albums
3,799
Uploaded media
22,708
Embedded media
19
Comments
425
Disk usage
2.2 GB
teak on the left, mahogany on the right

teak on the left, mahogany on the right

  • 0
  • 0
photo taken from sand island. Ansucian tied up at the sand island dock looking towards St. Helens Oregon..... columbia River

photo taken from sand island. Ansucian tied up at the sand island dock looking towards St. Helens Oregon..... columbia River

  • 0
  • 0
the original location of the galley

the original location of the galley

  • 0
  • 0
chain plate sealed.... one nicely applied application of the right stuff.

chain plate sealed.... one nicely applied application of the right stuff.

  • 0
  • 3
excess slack filled and faired with epoxy putty

excess slack filled and faired with epoxy putty

  • 0
  • 0
a nice clean surface to work with

a nice clean surface to work with

  • 0
  • 0
a small stainless steel wire brush like welders use is great for cleaning and removing old caulking.... never use a regular steel wire brush, stainless only.

a small stainless steel wire brush like welders use is great for cleaning and removing old caulking.... never use a regular steel wire brush, stainless only.

  • 0
  • 0
remove fairing plate and dig out old caulking to expose the depth of the damaged area

remove fairing plate and dig out old caulking to expose the depth of the damaged area

  • 0
  • 0
silicone is good stuff, but only if the surface is prepared for it. still, there is better stuff to use than silicone

silicone is good stuff, but only if the surface is prepared for it. still, there is better stuff to use than silicone

  • 0
  • 4
very ugly.... and even with three layers applied by differt people, it STILL leaked.... go figure! I found three layers that i could positivly identify, there were possibly more.... a shoe goo type stuff on top, silicone under it but on top of the fairing plate, and the original stuff under the plate.

very ugly.... and even with three layers applied by differt people, it STILL leaked.... go figure! I found three layers that i could positivly identify, there were possibly more.... a shoe goo type stuff on top, silicone under it but on top of the fairing plate, and the original stuff under the plate.

  • 0
  • 0
Sunburst at rest

Sunburst at rest

  • 0
  • 0
Never Forget 9/11/2001

Never Forget 9/11/2001

  • 0
  • 0
USNA '74 Gray Goats

USNA '74 Gray Goats

  • 0
  • 0
dave and sheri

dave and sheri

  • 0
  • 0
IMG 3262

IMG 3262

  • 0
  • 0
Rick and Nancy on boat

Rick and Nancy on boat

  • 0
  • 0
Nan Sea after detailing

Nan Sea after detailing

  • 0
  • 0
Nancy on Nan Sea

Nancy on Nan Sea

  • 0
  • 0
Me on the boat

Me on the boat

  • 0
  • 0
Mission Bay SD

Mission Bay SD

  • 0
  • 0
Channel Cruising Club raft in Mission Bay

Channel Cruising Club raft in Mission Bay

  • 0
  • 0
Dana Point

Dana Point

  • 0
  • 0
Tres Amigas

Tres Amigas

  • 0
  • 0
Dolphin escort

Dolphin escort

  • 0
  • 0
Top Bottom