Media
Navigation
Media comments
-
Finished!Those replacement bulkheads look great and appear to match well to the other woodwork I can see in the photos. I'll try to figure out how to... -
SERENITYYou can use both panels at the same time. Because they are completely seperate sytems. The only reason you have a master over ride switch on you... -
SERENITYI am replacing the original panel all together. The original panel is not waterproof and is down by the floor. I'm also adding circuits. The...
-
SERENITYYes, you can have the DC panel & the AC panel active at the same time. They are electricity seperate systems.
-
SERENITYAnd you don't have an override like on a house generator breaker, you just make sure all switches except your master/battery switch are off while...
Media statistics
- Albums
- 3,799
- Uploaded media
- 22,708
- Embedded media
- 19
- Comments
- 425
- Disk usage
- 2.2 GB
Firefly chainplate hole- A view of how our decks are attached to our hulls. The longer screw is the primary attachment, a #10x1.5" screw, under the toerail. The shorter screws are also #10x1.5" (the length varies between 1.25 and 1.5") and attaches the toerail to the hull. There are also horizontal screws holding the toerail in, and they are #10x1".
- Firefly_L28
- Aug 15, 2013
- 0
- 0
Firefly newwood- View upon completion of plywood rot repair. Replaced rotted plywood with new oak boards of the same dimensions. Used 5200 to bond to the hull. Had to remove the toerail in order to get at the deck-hull joining screws! Replaced and resealed the toerail with new screws (mostly) and 5200, of course.
- Firefly_L28
- Aug 15, 2013
- 0
- 2