Put a new propeller on my 1" shaft.
The old propeller was held on by two nuts and no cotter pin. I ordered a castle nut but even utilizing the thinner jam nut I can not get access to the cotter pin hole in the shaft. I need about another 1/4" before the hole lines up and there is too little meat left on the shaft to drill a new cotter pin hole.
Any suggestions? I really do want to use a cotter pin here.
The old propeller was held on by two nuts and no cotter pin. I ordered a castle nut but even utilizing the thinner jam nut I can not get access to the cotter pin hole in the shaft. I need about another 1/4" before the hole lines up and there is too little meat left on the shaft to drill a new cotter pin hole.
Any suggestions? I really do want to use a cotter pin here.
Attachments
-
479.5 KB Views: 244
-
647.9 KB Views: 211