I just completed a modification that I really wanted.
The Back Stay on the H33C is split and anchored just behind the wheel on each side. Whenever I needed to go forward,my shoulder would get caught in it and that was bugging me.
I had two 33 ft 3/16 back stays made with swage studs on one end and a fork at the other. I then cut the original back stay 9 ft 4 in from each end. I used wire clamps (two on each ends) to slice the two length together. I was able to adjust the 1/4 in original stay parts by sliding them. I think it's about 9ft 5in now. The cost wasn't bad and now it's freedom. It made such a difference. I now can comfortably go from the helm to the cabin to without having to twist and bend.
A definite improvement. I'll post some photos.
Cheers,
Sylvain
The Back Stay on the H33C is split and anchored just behind the wheel on each side. Whenever I needed to go forward,my shoulder would get caught in it and that was bugging me.
I had two 33 ft 3/16 back stays made with swage studs on one end and a fork at the other. I then cut the original back stay 9 ft 4 in from each end. I used wire clamps (two on each ends) to slice the two length together. I was able to adjust the 1/4 in original stay parts by sliding them. I think it's about 9ft 5in now. The cost wasn't bad and now it's freedom. It made such a difference. I now can comfortably go from the helm to the cabin to without having to twist and bend.
A definite improvement. I'll post some photos.
Cheers,
Sylvain