Just bought a 1986 Hunter 34. It has the spinnaker, halyard, and pole but no other hardware or running rigging. Any help with a shopping list specific to this size or model. Also length and diamater of sheets?
to make sure they are the right size for your winch and tailers that you intend to use for your spin clew sheets. We went with 7/16 and they were almost too small. Terry
On my 28.5 I have 1/2 inch sheets. Same diameter as the jib/Genoa sheets. Length should be about twice the length of the boat each. Tie them to the tack using bowlines with the tag end inside of the bowline so it doesn't hang up when tacking. Halyard should be the same as the main halyard. Snap blocks should be attached as far back as possible to both of the aft corners with the sheets being fed through them from outside the lifelines. Use a short halyard from a rollar block at mid mast to hold up the wisker pole. Go to North U. for more information. Best of luck.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
