Spinnaker Operating Manual

Status
Not open for further replies.
M

Mike Whalen

In an attempt to eliminate some of the error from my trial and error I have a question. I've had my 25 since August and haven't used the spinnaker yet. Never had one before. I did pull it out to inspect it. I have a good sturdy long extending pole. The haylard is set. The hardware is ok I think (blocks mounted on deck near shrouds, blocks aft near transom, and cleats on transom) The clew and tack are marked. I forget which but one has one line the other has two. The single line is heavier, the two lines are very similar. I was told that the single line grommet takes the pole and that line leads to the mast. and the other two are the sheets. Is that right? seems odd that sheets. I plan to run it up and play with it. I assume this sounds like the last words of the redneck - - Hey bubba watch this! but I'll wait till wind is light, no othe boats around and the risk of death thus low. Any guidance? Thanks, Mike
 
J

Justin - O'day Owners' Web

Try to find and experienced crew.

Mike - Playing with it is not a bad idea, but if you're going to do it you should really bring someone experienced with flying a chute. They can be a real bear to handle and can develop serious power in even light winds.. You do not want the boat to get away from you. That said - are we talking symetrical chute or asym/cruising? Would be helpful to know to help you sort your rigging. Justin - O'day Owners' Web
 
M

Mike Whalen

running spinnaker

I was told it is a "running spinnaker" I'm gonna take some measurements this week. It seems kinda narrow at the foot but I don't have any measurements. I'll take a photo shile I'm at it. I've been asking the guys around me and they don't run them gotta find some of the racing folks. Thanks, Mike
 
Status
Not open for further replies.