I am replacing my existing Ray Marine Radar with a Garmin unit. This requires that we pull the old cable from the mast to the helm and run a new one. Has any one done this on a Hunter 38? Can you tell me where the cable runs once it exits the mast below the deck?
We tried pulling up the floor boards to look. My center salon forward floor board has four screws holding it down but it is also glued down so it cannot be pulled up. I wonder if our dealer (now defunct) did this on the radar install? Dont know why you would screw the floor down and also glue it. Is this normal?
Also there is a small portion of the floor next to the compression post that looks like it should be removable. Any experience taking that out?
Any advice on this task appreciated.
We tried pulling up the floor boards to look. My center salon forward floor board has four screws holding it down but it is also glued down so it cannot be pulled up. I wonder if our dealer (now defunct) did this on the radar install? Dont know why you would screw the floor down and also glue it. Is this normal?
Also there is a small portion of the floor next to the compression post that looks like it should be removable. Any experience taking that out?
Any advice on this task appreciated.