The sail on my 331 is very difficult to pull out of the mast. I’m pretty sure it is the Outhaul car that is the problem because I can manually pull the sail out at the mast by hand but very difficulty using the control line. so I cleaned the ball bearings in the car and it got a lot better but unfortunately I made the mistake of pulling the car off the track to see if I could ”get it even better” and of course the ball bearings flew everywhere all over the entire boat.
Fast forward two weeks and I now have a bag of new balls I just need some help on how to get these installed without using a pre-loader tool, is this possible or do I need to buy this tool? Has anyone had any luck with this or should I go buy a tool for it?
Fast forward two weeks and I now have a bag of new balls I just need some help on how to get these installed without using a pre-loader tool, is this possible or do I need to buy this tool? Has anyone had any luck with this or should I go buy a tool for it?
Attachments
-
312.4 KB Views: 132
-
585.4 KB Views: 147