No power to the engine control panel

P

PThomas

.
Apr 20, 2016
21
Hunter 34 New Bern
Hello
I have a 1984 Hunter34 up until now it started flawlessly
So I went to start the boat and nothing not a thing no lights no power at the control panel all the other electronics work I do have a separate starting battery. The starting battery does seem to be good but did not have time to do a real check but it reads correctly on the multi meter but I did not have my load tester with me I could not find any broke wires is there a fuse somewhere that I am missing? And if all else fails any recommendations on a good mechanic in the New Bern, NC area I am sure it’s simple that’s why I can’t figure it out

Thanks
 
kloudie1

kloudie1

.
Nov 6, 2006
10,103
Hunter 34 Mandeville Louisiana
There is a 30 ampere fuse in a little green plastic case on the port side of the engine . This picture shows the holder. It is a pretty shabby holder and its connections are not the best. A little aft and below the air cleaner. I hav also attached the Yanmar panel wiring diagram.
P1030597.JPG
 

Attachments

  • Like
Likes: PThomas
Johnb

Johnb

.
Jan 22, 2008
1,461
Hunter 37-cutter Richmond CA
I second Claude's diagnosis - engine vibration alone can make that fuse get displaced.

Good luck.
 
  • Like
Likes: PThomas
P

PThomas

.
Apr 20, 2016
21
Hunter 34 New Bern
Thank you for the info I do not remember seeing the fuse holder so now I have a good starting point to look for it
again Thanks so much
 
You must log in or register to reply here.

Top Bottom