I was looking for a place to install my 10" water filter assembly and I came across this original install for my twin galley sinks. Other than probably replacing the PVC elbow connected to the thru-hull valve, do you see anything wrong with this setup? Mostly, does it need the "trap" seen below the cabinet base? Would it be better to shorten the hose? Traps are usually added as an air seal but I don't see the need here.
BTW, I decided to install the filter cartridge on the starboard side behind the teak bulkhead in the sitting space. That gives me enough room to replace it when needed. It's close enough to the water pump to keep the lines short. Pics to follow when I'm done.
BTW, I decided to install the filter cartridge on the starboard side behind the teak bulkhead in the sitting space. That gives me enough room to replace it when needed. It's close enough to the water pump to keep the lines short. Pics to follow when I'm done.