HOLDING TANK
I put in a 20 gal tank in the bow 2 years ago. I had to cut out most of the storage shelf under the V-Berth in order to get it in. I made a plywood "bed" shaped to the bottom of the tank, cut @ 10 3" holes in the "bed", placed it in the bottom of the hull. I fed a deck clean out and ran the hose underneath the "bed". Then I used non-expanding foam to fill in under the bed. This secured and glued the "bed". I then placed the tank on top of the "bed" and then using the same non-expanding foam, filled in the sides, securing the tank in place. Two fresh air vents (port vent out stbd, etc.). I put an electric macerator and new thru-hull under V-Berth on starboard with an on-off switch in same locationl. I put a 6" deck plate on wall between head and V-Berth -- I can unscrew it and reach through to open thru-hull and turn on switch. This way I don't have to clean off the top of the V-Berth to get to the discharge end. Y-Valve behind head. davidtrace@shaw.ca
