Hunter 49/50 alternator wiring
- Thread starter Laid-back
- Start date
That's probably the field wire, and there should be a receptacle for it on the back of the alternator.
Are you're talking about the short wire with a receptacle attached thats on the alternater? I have that and it goes to nothing, I believe, but could be very wrong, that it's a ground wire, but our alternaters are already grounded to the engine. So not needed.
In my case that's how its always been working.
In my case that's how its always been working.
I determined that this wire goes to a tach, which is not required here so the wire is not used.
I can't find the file in downloads, but here's an old discussion:
Hunter 49/50 impeller replacement
Hi folks, I posted a very comprehensive writeup on how to fix the dreaded impeller replacement fiasco on the 49/50. Has anyone completed this project? Mine has worked perfectly!!! Oops typo. Meant H50. Don't think they make a 60 yet
forums.sailboatowners.com
I recently replaced the turbocharger on my 4jh4 HTE and stumbled onto a short cut you might be interested in for changing the impeller. Removing the three bolts and the two hose clamps on the exhaust manifold allows great access to the raw water pump. It is relatively easy to reach in and remove the bolts and impeller. I think it’s less hassle than removing the alternator. Turns out, the old turbo was fine as was the exhaust elbow, which I found out was bronze and bullet proof. I went ahead and replaced the turbo anyway since I had many hours invested in taking everything apart to gain access. I was also worried because I didn't hear a turbo whine when throttling up. I learned later that low pressure turbos don't always emit a distinct whine like high pressure turbos do. The new turbo sounds exactly like the old one. This information might be helpful for Hunter 49/50 owners with over 1000 hours on their engine who are contemplating replacing their turbocharger as scheduled maintenance.
