This is why I specifically stated that this approach works for the Great Lakes and upper mid-west. Not everywhere. I also noted variables such as in water vs on the hard storage and covered vs uncovered.Venting and desiccant... I think the math does not work as you think. Is there still desiccant in the spring, when you open the boat? But it works because you are not in a damp climate, compared to coastal areas with ocean-warmed water. In boats with wet bilges and warm water, the desiccant would only last a few weeks or a month. Yup, tested that. Basically, you are drying the great outdoors, if there are vents.
Relative humidity in Seattle is about 85-90% through the winter. Very high. Think fog inside the boat some nights! Different. It is also considerably warmer, meaning the air holds more water at a given RH.
Coastal MD and coastal Maine are about 80% RH. Chicago is colder and about 75% RH.
Also, mold does not grow when it is sub-freezing. Nothing does. IME, it is a spring thing.
Also, the OP keeps his boat in the water. That makes a BIG difference, since any water in the bilge will condense in the cold cabin(the water is considerably warmer than the air).
Complicated.
The math works exactly as I think. In this climate. From October through April or mid-May. And yes, there is still desiccant left in the spring. As you alluded to, comparing relative humidity without consideration of temperature does not express absolute humidity or actual moisture in the air. Cold winter air in Chicago is extremely dry. Summer is the opposite, often oppressively humid. That‘s when venting and desiccant would indeed be a futile combination, but that’s not when we store our boats here. Yeh, complicated.
I am aware that the OP is in the PNW, much of which is uniquely classified a cold rain forest, and I also see that people responded from coast to coast. Some are in the same climate. Others are not. It’s a national forum, international actually, and that’s why I took the time to respond. Maybe that was a waste of time.