Hi Folks,
Looking to install a 'secondary' winch next to existing Stb side to be dedicated solely to the STB Jib sheet.
I found this pic (attached)... so someone has done it somewhere.
Just wondering if there's a specific location that still utilises the impregnated Alum strengthening plate... or would I just bang it in where it kinda fits?
I think I can access for nuts n washers from an inspection panel in the head/bathroom. I club race 'Chummy' down here in QLD Australia and always seem to be one winch short in the heat of battle haha.
Any tips and ideas most welcome cheers - Mark Mac
Looking to install a 'secondary' winch next to existing Stb side to be dedicated solely to the STB Jib sheet.
I found this pic (attached)... so someone has done it somewhere.
Just wondering if there's a specific location that still utilises the impregnated Alum strengthening plate... or would I just bang it in where it kinda fits?
I think I can access for nuts n washers from an inspection panel in the head/bathroom. I club race 'Chummy' down here in QLD Australia and always seem to be one winch short in the heat of battle haha.
Any tips and ideas most welcome cheers - Mark Mac
Last edited:
