Engine Kill lever on Catalina 30

T

Trinity 2022

.
Aug 28, 2022
1
cataline 30 Glen Cove
I own a 1986 Catalina 30 just Since July. The kill engine Lever just became difficult to push down and pull up. is this common? Should lever be pushed in when the engine is off? I pushed down hard on teh lever and the fiberglass cracked around it. will that cause any issues.
Inquring minds need to know.
Trinity
 
Davidasailor26

Davidasailor26

.
May 17, 2004
5,713
Beneteau Oceanis 37 Havre de Grace
It definitely shouldn’t be that hard to push the lever back in, and you should be able to do it as soon as the engine stops.

You may need to disconnect the cable from each end to see what’s causing the friction.
 
D

dlochner

.
Jan 11, 2014
13,037
Sabre 362 113 Fair Haven, NY
Yes, it should move easily. Push the lever in as soon as the buzzer sounds, if you leave it out sooner or later you will be buying a new cable.

Trace the cable through its path to the engine. Look for sharp bends. The cable may need lubrication, a few drops of oil or replacing. Replacing the cable is not a technically difficult task, although it may require you to be a contortionist to run the cable.
 
shemandr

shemandr

.
Jan 1, 2006
7,619
Slickcraft 26 Sailfish
According to Mack Boring (Major Yammie dealer) the.cable needs lubrication from time to time. I found that I could put a few drops of light oil on the cable while it is out and then work it in and out and repeat. Mine wasn't that bad. MB Rx'ed taking the whole inner cable out to lubricate. That can be a difficult job. At that point I'd be thinking replacement and do regular lubrication to maintain it.
 
JoeWhite

JoeWhite

.
Mar 6, 2008
1,363
Catalina 1999 C36 MKII #1787 Coyote Point Marina, CA.
Disconnect from engine end and test if it is hard to pull or push. It is easy to replace. I replaced mine as the handle end broke. I had not realized that it was hard to pull until I installed the new one. The length of the cable is marked on the cable, you will see it after you remove it. PM me if you need a source to buy from. Catalina Direct has the wrong size. Ask me how I know.
Visit this link on my website

Engine Stop Cable | Sail La Vie

mei1970.org mei1970.org
 
Last edited:
  • Like
Likes: FastOlson and LloydB
L

LloydB

.
Jan 15, 2006
927
Macgregor 22 Silverton
While we're here I'd like to ask maybe a silly question but but I don't know the answer and I am curious. Does the manufacture call it a engine kill lever or a fuel shutoff lever? Just my opinion but besides the cable repair the fiberglass should also be repaired at this time.
 
You must log in or register to reply here.

Top Bottom