Dipstick
- Thread starter rblevens
- Start date
Looking from the front of the engine, it's should be on the Left side of the engine (oppoiste side of air filter) toward the lower rear - just before the bell to the transmission.
dip stick
looks about right size. is it that you dont see it on the motor ?? if you looking at it from the front its on the left side close to the back really lowalmost to the oil pan. hope that helps
Measurements are as follows
From the end to the shoulder that limits insertion 6 7/8 inches
From the end to the end of the cross hatched section 1 3/8 inches
Diameter of the section with the O ring 1/2 inches
Diameter of the shoulder that limits insertion 5/8 inches
From the end to the shoulder that limits insertion 6 7/8 inches
From the end to the end of the cross hatched section 1 3/8 inches
Diameter of the section with the O ring 1/2 inches
Diameter of the shoulder that limits insertion 5/8 inches
