Using a Compass
When using a map on land, the term declination refers to the local magnetic field found in the environment that will affect the compass's reading. When using a nautical chart, the term for local magnetic field in the environment is called variation. Another term used on the water is deviation. Deviation is the magnetic field found on the ship which will affect the ship's compass such as speakers (magnets) in the cockpit. Compass deviation card or compass error cards shows the deviation the compass reading must be adjusted to by adding or subtracting the error. A compass deviation card is generated by "Swinging" the compass. This is done by sailing a complete 360 degrees and using fixed land points to check the ship's deviation with a hand held compass. For inshore sailing you can swing your own compass, but if you are going to sail blue water, I would have a professional compass adjuster do the swinging and certify the compass deviation card.For sailors, only the terms variation and deviation are used to describe errors added or subtracted to get magnetic heading. The other terms are used for non-sailors."The geomagnetic field can be quantified as total intensity, vertical intensity, horizontal intensity, inclination and declination. The total intensity is the magnetic strength, which ranges from about 23 microteslas (equivalent to 23000 nanoteslas or gammas, or 0.23 oersteds or gauss) around Sao Paulo, Brazil to 67 microteslas near the south magnetic pole near Antarctica. Vertical and horizontal intensities are components of the total intensity. The angle of the field relative to the level ground is the inclination or dip, which is 90° at the north magnetic pole. Finally, the angle of the horizontal intensity with respect to the north geographic pole is the declination, also called variation in mariners' and aviators' jargon. In other words, declination is the angle between where a compass needle points and the true North Pole... A beginners guide to understanding magnetic declination by Chris M. Goulet, Montreal, Canada."The GPS will calculate a true and magnetic heading, depending on how you setup your GPS. Most GPS has a function called "AutoMag" which has stored variation values based on your actual position to convert true to magnetic. The primary purpose of the GPS is to provide a position fix. For heading and speed, the GPS takes two reading to calculate the change in position due to speed and direction to provide an averaged speed value and average course heading. Since it is not instantaneous but must be done over some time interval and movement of the ship, an error factor due to changes occurring during the time interval and ship's movement is introduced. A compass reading is instantaneous, the ship doesn't have to be moving or be measured after some time interval.You can Swing your own compass, there are books you can get providing different methods and ways to swing your own compass to get different degrees of accuracy.Fair Winds,Clyde