B&G Vulcan 7 power cable "pin-out"

[ricksoth]

I acquired a Vulcan 7 but it came without a power cable for the 4 pins on the back. The cable is available for $42 which I will purchase but was hoping to bench test it first but the B&G manual naturally does not show the "pin-out" for the plug. Does anyone have this info or have a Vulcan 7 they might be able to disconnect the power supply for and share which pin the + & - are on (red, black, yellow, blue). See image attached.

Other units that use this power cable are: Simrad B&G 4-Pin Power Cable for Go/NSS evo3 & Vulcan/Zeus3 Displays.

Thank you.

 

[Don S/V ILLusion]

Doesn’t the drawing you attached show this?

 

[WayneH]

Doesn’t the drawing you attached show this?

Don, the OP is looking for the other end of the cable which the manual does not illustrate anywhere. At least, I haven't found it in my manual.

Rick, I am 700 miles from my B&G so I can't help you out.

 

[Don S/V ILLusion]

Don, the OP is looking for the other end of the cable which the manual does not illustrate anywhere. At least, I haven't found it in my manual.

Rick, I am 700 miles from my B&G so I can't help you out.

I know. Tracing the pin out on the opposite end is as simple as doing a continuity check - pin 1 to pin ? on opposite end. Am I missing something?

 

[ricksoth]

I found the information late last night on another installation manual. Thanks to all who commented.

 

[s/v-Windsong]

I found the information late last night on another installation manual. Thanks to all who commented.

This is incorrect. Your first picture was correct pin 2 is positive and 3 is negative

 

[JBP-PA]

I know. Tracing the pin out on the opposite end is as simple as doing a continuity check - pin 1 to pin ? on opposite end. Am I missing something?

He doesn't have the cable. "...came without a power cable..."

 

[s/v-Windsong]

He doesn't have the cable. "...came without a power cable..."

I did it yesterday without a cable to make sure it was working