Posting here because this forum always seems the most resourceful, but if there is a better place, pls advice and I can move. I have an B&G H1000 a/p that I am having trouble calibrating in the "at dock" calibration process. I've already swapped out to a known working ACP "brain". When I try and complete the "hard over" at-dock calibration I get the error msg "Attention - Pilot Un-calibrated. refer to instruction manual for details". Of course the manual doesn't detail this message. Prior to the "hard over" step, I completed the "port" and "stb" rudder stop settings., but there is no way to confirm it's actually "set" (?) The only other piece of info i have is that I can confirm I have voltage in to the ACP computer, but the "drive" terminals do not have voltage, and I don't know if that is a factor of the "brain" not getting a proper signal from a sensor (rudder?) or the instrument controller. So just wondering if anyone has any troubleshooting advice on what to test and confirm next.
Many thanks
WSC
Many thanks
WSC
Attachments
-
306.7 KB Views: 521
-
445.5 KB Views: 478