Sailboat Owners Forums

Pulled the boat out to wash down the sanding dust. This is port side with no work done...
cables run down into the V-berth
Routing the wind transducer wire... I used micro C through deck connectors, and spliced the simnet cables.. we'll see if it worked. The wiring inside a simnet cable is identical to NMEA 2000, the connectors are just different.. I just needed a solution to allow me to disconnect the transducer for trailering.
Better shot of the masthead, I installed an LED anchor light too.
Masthead after wiring was done.
Huge repair job done years ago, and gelcoat was all mismatched, and down to gray undercoat in places. My attempt was to gelcoat over it this was the masking portion, after sanding.
Port cockpit seat getting gelcoated.
Top Bottom