Masthead after wiring was done.
cables run down into the V-berth
Routing the wind transducer wire... I used micro C through deck connectors, and spliced the simnet cables.. we'll see if it worked. The wiring inside a simnet cable is identical to NMEA 2000, the connectors are just different.. I just needed a solution to allow me to disconnect the transducer for trailering.
Better shot of the masthead, I installed an LED anchor light too.
Masthead after wiring was done.
Huge repair job done years ago, and gelcoat was all mismatched, and down to gray undercoat in places. My attempt was to gelcoat over it this was the masking portion, after sanding.
Port cockpit seat getting gelcoated.
my project, a shelf for under the stereo, to prevent people from smacking the radio while sitting on that berth.
shnool

Masthead after wiring was done.

There are no comments to display.

Media information

Album
S2 gets an overhaul...
Added by
shnool
Date added
View count
366
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
24163-1430925689-3497f17f751834891650fa2d92483fec.jpg
File size
60.9 KB
Dimensions
800px x 600px

Share this media

Top Bottom