Media
Navigation
Media comments
-
Finished!Those replacement bulkheads look great and appear to match well to the other woodwork I can see in the photos. I'll try to figure out how to... -
SERENITYYou can use both panels at the same time. Because they are completely seperate sytems. The only reason you have a master over ride switch on you... -
SERENITYI am replacing the original panel all together. The original panel is not waterproof and is down by the floor. I'm also adding circuits. The...
-
SERENITYYes, you can have the DC panel & the AC panel active at the same time. They are electricity seperate systems.
-
SERENITYAnd you don't have an override like on a house generator breaker, you just make sure all switches except your master/battery switch are off while...
Media statistics
- Albums
- 3,799
- Uploaded media
- 22,708
- Embedded media
- 19
- Comments
- 425
- Disk usage
- 2.2 GB
Some instruments. The sonar and compass flip up on the hinge and are held by the bungy in my hand. A little voltmeter is wired to one of the circuits for battery monitoring. The little black speaker is a radio shack cheapie jacked into the VHF radio (out of the picture to the right under the stove). It really helps hearing the radio. The traveler ropes can be seen just outside.
- Chris14830
- Aug 31, 2010
- 0
- 0
Looking up in quarter berth. The jib cam cleat backing washers and nuts are lower left, Genoa track across the top (backing plate on the last two bolts as my track goes past the winch, great for downwind). Winch backing plate in the center as I raised my winch up an inch or two.
- Chris14830
- Aug 31, 2010
- 0
- 0
Mainsheet traveler, the manual pin adjuster (not used now) is under the right hand block. The left block is called a "single block with becket and universal head", the right "fiddle block with adjustable cleat and universal head". These blocks supposedly take 5/16" rope, I found they worked better with 1/4". Works great!
- Chris14830
- Aug 31, 2010
- 0
- 0
