Media
Navigation
Media comments
-
A1975 o'day 22will be changing to led lights both mast and cabin along with nav lights. adding solar, adding bbq, rebedding all deck hardware and below water...
-
-
MacGregor 26sDas sind Teakleisten, die aufgeklebt, dann mit Schwarzer Masse ausgegossen und geschliffen wurden. Sieht immer noch aus wie neu.....
-
-
Media statistics
- Albums
- 3,799
- Uploaded media
- 22,708
- Embedded media
- 19
- Comments
- 425
- Disk usage
- 2.2 GB
IMG 1230 This rot damage came from water down the mast over time. My 1984 Catalina 30 masthead fitting is open to the sky at the top! Since I had the mast pulled to do this compression post repair, it now has an aluminum plate to cover the opening. Note the hole that the mast wiring came through, in the upper left part of the wood.
- rbmcintire
- Feb 27, 2011
- 0
- 0
IMG 1369 Note bottom two inches of PVC wiring conduit showing some previous water "level" inside the post box. Catalina factory drills a hole down through the post support and into the bilge so the mast wires can continue back to the nav station switches. Rain comes down the wires, and over time, rots the block.
- rbmcintire
- Feb 27, 2011
- 0
- 0
IMG 1372 Aft compression post board removed. It is screwed and glued. Work a sturdy, new, sharp putty knife carefully up the joint. After opening the seam (quite a lot), I speeded things apart using a Rockwell SonicCrafter. Recommend it or a similar Fein "Multi-Tool" highly
- rbmcintire
- Feb 27, 2011
- 0
- 0
