Media

Navigation

Browse albums

Media comments

  • ToddL214
    Finished!
    Those replacement bulkheads look great and appear to match well to the other woodwork I can see in the photos. I'll try to figure out how to...
  • Captain Grey Beard
    SERENITY
    You can use both panels at the same time. Because they are completely seperate sytems. The only reason you have a master over ride switch on you...
  • Captain Grey Beard
    SERENITY
    I am replacing the original panel all together. The original panel is not waterproof and is down by the floor. I'm also adding circuits. The...
  • Captain Grey Beard
    SERENITY
    Yes, you can have the DC panel & the AC panel active at the same time. They are electricity seperate systems.
  • hudson_rogue
    SERENITY
    And you don't have an override like on a house generator breaker, you just make sure all switches except your master/battery switch are off while...

Media statistics

Albums
3,799
Uploaded media
22,708
Embedded media
19
Comments
425
Disk usage
2.2 GB
First Interlux2000e coat

First Interlux2000e coat

  • 0
  • 0
starboard fiberglas woork

starboard fiberglas woork

  • 0
  • 0
mast core fixed

mast core fixed

  • 0
  • 0
Bow Nav Lights Front

Bow Nav Lights Front

  • 0
  • 0
Chain Plate Sealing

Chain Plate Sealing

  • 0
  • 0
Scribed and cut the wall to fit and re-installed. I will add more pics of the cutain rods and curtains when we finish.

Scribed and cut the wall to fit and re-installed. I will add more pics of the cutain rods and curtains when we finish.

  • 0
  • 0
Screwed it in place to the 2 x 4 cleat and it rests nicely on the seat and the ledge.

Screwed it in place to the 2 x 4 cleat and it rests nicely on the seat and the ledge.

  • 0
  • 0
First a dry fit

First a dry fit

  • 0
  • 0
Installed a 2 x 4 though bolted to the v-berth with s.s. screws and lock nuts

Installed a 2 x 4 though bolted to the v-berth with s.s. screws and lock nuts

  • 0
  • 0
Assembled with exterior 1/4" plywood and hung. I shot two coats of white epoxy followed by two coats of polyurethane

Assembled with exterior 1/4" plywood and hung. I shot two coats of white epoxy followed by two coats of polyurethane

  • 0
  • 0
I assembled both legs onto a 2 x 6 using exterior screws and glue.

I assembled both legs onto a 2 x 6 using exterior screws and glue.

  • 0
  • 0
Starboard leg in place to check fit

Starboard leg in place to check fit

  • 0
  • 0
Measured out to cut the height

Measured out to cut the height

  • 0
  • 0
After the first two cuts

After the first two cuts

  • 0
  • 0
I transferred the height to the side walls using a 2x6 to keep the angle.

I transferred the height to the side walls using a 2x6 to keep the angle.

  • 0
  • 0
I scribed the 'leg' to match the different angles and cut it to fit.

I scribed the 'leg' to match the different angles and cut it to fit.

  • 0
  • 0
This image shows how far we moved the wall. An 8.25" change.

This image shows how far we moved the wall. An 8.25" change.

  • 0
  • 0
We moved around the porta potty (we raised it to reflect the height of the larger unit I bought on Craig's List) to see how much room we could steal from the head area. After removing the door we gained leg room out into the isle.

We moved around the porta potty (we raised it to reflect the height of the larger unit I bought on Craig's List) to see how much room we could steal from the head area. After removing the door we gained leg room out into the isle.

  • 0
  • 0
First step was to remove the forward head wall.

First step was to remove the forward head wall.

  • 0
  • 0
Removing the tongue jack. It wouldn't move!

Removing the tongue jack. It wouldn't move!

  • 0
  • 0
Had not seen the water for over 10 yrs!

Had not seen the water for over 10 yrs!

  • 0
  • 0
Our first look when we pulled back the "road" Deep in the hills of Ky.

Our first look when we pulled back the "road" Deep in the hills of Ky.

  • 0
  • 0
My primary concern is the hole for the mast. A previous owner obviously shared my concern.

My primary concern is the hole for the mast. A previous owner obviously shared my concern.

  • 0
  • 0
View of the cockpit. Looks good for her age.

View of the cockpit. Looks good for her age.

  • 0
  • 0
Top Bottom