DSC01466As I mentioned previously, I usually shore up under the stern with blocks first just as a precaution. I don't know why I didn't do it this time.
DSC01469 As I mentioned, these keel/centerboard O'Days can take the full weight of the boat with the keel sitting on blocks. I don't think that the Catalina sloops can do this but I may be wrong.
DSC01468 This is just the initial set up on the shoring. When I get ready to raise the boat, I'll block up under the stern and bow, as close to the front of the keel as possible, and start raising the boat with the five stands. I shore up as I raise the hull.
DSC01467She's almost free of the trailer. I yoost take my time when I do dis. You can't rush "deze tings" you know. (Just practicing my Scandinavian accent.)
DSC01466As I mentioned previously, I usually shore up under the stern with blocks first just as a precaution. I don't know why I didn't do it this time.
DSC01465 It's a slow process, I know, but it's the best way I know of doing this right now. A faster way and easier way to do this would be to support the bow with a long metal eye beam supported high enough to allow the trailer to be rolled right out from under the boat. I would shore up under the keel just as soon as it's clear of the back of the trailer. Then the beam could be removed. Two of the stands can also be move toward the bow of the boat about 6' or 8' from the other two stands on the stern. The keel of this boat can take the full weight of the boat while sitting on blocks with at least two stands to keep it from tipping. Two sailboat stands can be placed temporarily under the stern of the boat to keep it from tipping. Preferably, the more stands the better. I use four sailboat stands and one powerboat stand under the bow of the boat with the keel sitting on blocks. The boat needs to be level at all times when you raise/lower the hull with stands and the jack. Five of my stands can raise my boat with no problem. Is this dangerous? You bet it is. I take every precaution when I do it.
DSC01464 A tall car stand can be used in place of the powerboat stand. Once the powerboat stand is against the front of the trailer's cross member, I need to jack the boat up again and move the powerboat stand to the back side of the same or another cross member in order to move the trailer ahead a little more.
DSC01463 I'm jacking the bow of the boat from the trailer and using a straight powerboat stand to hold the height so that I can let the jack down and move the trailer ahead by hand and reset the jack again.
Joe11688

DSC01466As I mentioned previously, I usually shore up under the stern with blocks first just as a precaution. I don't know why I didn't do it this time.

There are no comments to display.

Media information

Album
Taking the boat off the trailer
Added by
Joe11688
Date added
View count
308
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
17059-1356644931-760ab69c3e689c660313c72fa414fdb7.jpg
File size
108.8 KB
Dimensions
800px x 600px

Share this media

Top Bottom