Cabin1209 V-berth "patterns". I cut the oval holes in these areas to acces space that would otherwise be inaccessible. I did this a few years ago in place, and in the replacement wood before installation.
DSCN8409 Where it all started, now finished.
DSCN8404 Interior nearing completion.
Interior5 Interior pieces prior to paint. Notice long strips along the V-berth section. Instead of placing the new section over the 2" section left behind, I scabbed these pieces underneath cut the new section to fall into place.
Cabin1209 V-berth "patterns". I cut the oval holes in these areas to acces space that would otherwise be inaccessible. I did this a few years ago in place, and in the replacement wood before installation.
Cabin3 Companionway view of stripped cabin.
Cabin1202 V-berth area. Notice the hole drilled on the forward vertical surface of the sole pan. This was glassed over, as was the aft hole. Water was retained, and at best would seep to where I could removed it, but caused the rot in the bulkheads adjacent.
Cabin1050 Bunks removed. Bunk supports were also removed and replaced. The bunks are glassed to the hull, so I cut them with a jig saw about 2" in, cut the new bunks from the pattern and added the 2", then installed them over the old edge and screwed them in.
Mark Major

Cabin1209 V-berth "patterns". I cut the oval holes in these areas to acces space that would otherwise be inaccessible. I did this a few years ago in place, and in the replacement wood before installation.

There are no comments to display.

Media information

Album
Gunwale core replacement and subsequent wood replacement
Added by
Mark Major
Date added
View count
377
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
4513-1241838794-c9ea29df64686f345022202adada9d73.jpg
File size
30.1 KB
Dimensions
600px x 450px

Share this media

Top Bottom