All Activity
-
:plus: Read about this a few weeks back. Very interesting! :beer: -
"Ironside", I remember that show. Thanks Raymon Burr... Ah... Jim. :dancing:
-
Huzzah! Fun fact, her "iron sides" are maintained by mature white oak sourced from land within Crane Naval Surface Warfare Center, down...
-
Ddlochner replied to the thread Replacing the cutlass bearing on a 1996 Beneteau 351.To pull the prop just get a gear puller large enough to reach around the hub...
-
jssailem replied to the thread Catamaran Sailing.Those small catamarans can be a lot of fun. They can be wet. A wetsuit or warm weather is advised. I always found that they tend to... -
After 40 some odd years of sailing mono-hull boats yesterday was my first experience sailing a catamaran. The boat was a Hobie Getaway...
-
jssailem reacted to BigEasy's post in the thread Deck hatches for US-made 2002 Oceanis 311 with
Helpful.
They should be Lewmar low profile hatches. Examine the lens thoroughly for inscribed size data on the edge of the acrylic lens... -
jssailem replied to the thread Replacing the cutlass bearing on a 1996 Beneteau 351.That generally means the use of a large sledgehammer Not Taps to the prop body. There are prop pullers that can help to remove the...
-
-
After 40 some odd years of sailing mono-hull boats yesterday was my first experience sailing a catamaran. The boat was a Hobie Getaway... -
Ddlochner replied to the thread Replacing the cutlass bearing on a 1996 Beneteau 351.While you're messing around there with the cutless bearing, check the shaft for scoring. It appears the set screw may be rubbing the...
-
-
Ralph Johnstone reacted to BigEasy's post in the thread Deck hatches for US-made 2002 Oceanis 311 with Helpful.
They should be Lewmar low profile hatches. Examine the lens thoroughly for inscribed size data on the edge of the acrylic lens... -
Johnb replied to the thread Replacing the cutlass bearing on a 1996 Beneteau 351.You should be super aware that any wacking pulling or hammering that transmits a force into the prop shaft results in that same force... -
BigEasy replied to the thread Deck hatches for US-made 2002 Oceanis 311.They should be Lewmar low profile hatches. Examine the lens thoroughly for inscribed size data on the edge of the acrylic lens... -
:plus: Read about this a few weeks back. Very interesting! :beer:
-
"Ironside", I remember that show. Thanks Raymon Burr... Ah... Jim. :dancing:
