All Activity
-
JoeWhite replied to the thread Thinking of replacing the ST60 wind instrument. Any suggestions?.I would go up the mast and bring down the nanometer and directly connect it to the display unit. This will indicate if the cable is the... -
JoeWhite reacted to dmax's post in the thread Thinking of replacing the ST60 wind instrument. Any suggestions? with
Like.
Before spending any money, clean up all the connections, especially at the mast base. Highly likely it's a cable problem. -
Ralph Johnstone replied to the thread Installing an in the hull transducer.Hi @Mike Oldak . This is certainly not meant as a criticissm of you, as your only following the instructions, but the idea of having to... -
Rick Webb replied to the thread Bridle Hoisting a Hunter 216?.A lifting bar may make sense for y'alls operation. I'll post a picture of the one I had made. It is for lifting our coach boats and are... -
Hayden Watson replied to the thread Tightening Engine Belt on Universal 5411.I ran into the same problem when I went with the serpentine belt kit for my high-output alternator. The Engineer in me also struggled... -
-
Hayden Watson reacted to jviss's post in the thread Tightening Engine Belt on Universal 5411 with Like.
I had a problem on my new serpentine belt and pulley upgrade where I not only couldn't get proper tension, but I ran out of adjustment...
-
MMike Oldak replied to the thread Installing an in the hull transducer.Me too! But that is what the directions suggested.
-
Everybody is always asking me what I carried for self defense aboard when cruising. I had my trusty 9mm, a couple of clips and a box of... -
Tally Ho replied to the thread Thinking of replacing the ST60 wind instrument. Any suggestions?.I would go with a Raymarine wireless wind (the old Tac Tic device). I have that on my O’Day 322 and it works well. I did replace my... -
jssailem replied to the thread Installing an in the hull transducer.I’ve heard of owners using mineral oil. Antifreeze is a new one for me. Well done. -
I just made a circular dam and then filled it with rv antifreeze so no air bubbles below transducer. Structure just provided a round...
-
thinwater replied to the thread Threaded closing mushroom vent?.I had one of these (I think) on my PDQ, and the way it works you can either spin it shut from the inside with the knob, or spin the... -
-
MMike Oldak replied to the thread Installing an in the hull transducer.I just made a circular dam and then filled it with rv antifreeze so no air bubbles below transducer. Structure just provided a round...
-
jssailem replied to the thread Installing an in the hull transducer.Nice. Does it work? If yes, that is when you know you got all the air out of the mix. You can sit back. Give out a big sigh and have...
-
sailcapt340 replied to the thread H41AC - Running Wires Above Headliner.Have you tried using a thin flexible wire as a snake in either of the two areas you can see where the wires exit from under the cowl or...
