All Activity
-
Hope to be back up on the boat in a couple days. Will take a look at the electrical panel, but mine has many less options than the 1999... -
jssailem replied to the thread Hunter 18 Spinnaker.It is available at. @kappykaplan suggests. Look in the downloads section. The owners manual uploaded 2013 will provide Hunter insight...
-
CChrisHunter replied to the thread Bilge Pump will not stop.Hope to be back up on the boat in a couple days. Will take a look at the electrical panel, but mine has many less options than the 1999...
-
jssailem reacted to Project_Mayhem's post in the thread Similar to the Illusion 12 but a mystery with
Ha.
Sign me up! -
jssailem reacted to JamesG161's post in the thread Tropical Storm Lala ---> Hurricane Lala with Like.
Pacific Area... Pa Aloha Jim...
-
Ralph Johnstone replied to the thread Cracked Weld in Arch (310).Good point. I can tell you that my boat arrived in Vancouver without the arch installed for shipping reasons. The arch was instaled on... -
jssailem replied to the thread Help-I've got hockles in my sheets and need to get them out!.@thinwater nailed the problem and the solution. Here are a couple additional ways of looking at the solution...
-
Some general thoughts. The foot of the arch should be separated from the hull. The heat developed while welding will most likely damage...
-
jssailem reacted to thinwater's post in the thread Help-I've got hockles in my sheets and need to get them out! with
Helpful.
That is a twist, not a hockle. A shackle with a swivel will not solve the problem. It will probably make it worse. You do NOT want a... -
thinwater replied to the thread Help-I've got hockles in my sheets and need to get them out!.That is a twist, not a hockle. A shackle with a swivel will not solve the problem. It will probably make it worse. You do NOT want a... -
JRacer replied to the thread Help-I've got hockles in my sheets and need to get them out!.Is that bottom block on the traveler set so it is free to spin? -
Jjoelm100 posted the thread Help-I've got hockles in my sheets and need to get them out! in Ask All Sailors.Hi all, this is probably a mundane question but I'm not finding anything on the forums. My Hunter 380's main sheet gets twisted up...
-
-
Joe replied to the thread Profurl C260 furler halyard slipping.I read the instruction manual for the 260 system. As you state, it has an internal halyard, encased in the foil that also serves as the... -
shemandr replied to the thread Cracked Weld in Arch (310).I enjoyed that video because I don't know anything about welding. I learned a bit. The welder said he expected to use 80 amps during... -
Pacific Area... Pa Aloha Jim... -
