All Activity
-
I will use the Boat Repair Yard to haul out my boat and secure it. $500 my cost. Lead time is about 12 hours. Jim... PS: best harbor =... -
Allan12210 replied to the thread Hunter 34 1984 Yanmar 3GMF issue.Creative solution for a desperate situtation. I'm reminded of when Curley tried to replumb the shower. I learned a lot from that... -
-
Different engine, same problem. The original exhaust riser and injection port separated about 14 nm offshore in a shipping lane with no...
-
Ralph Johnstone replied to the thread Cracked Weld in Arch (310).Have you stopped to consider how meaningless the term "crack in the weld" is to the many people on this site who are experienced (and in... -
BBC16385 posted the thread Hunter Passage 42; Has anyone replaced the Simpson Lawrence Anchorman Sprint 900 in Big Boats.Mine is a 1997 P 42. The anchor windlass is dead. Lewmar told me they have nothing that can be installed the same way as the original... -
-
Ralph Johnstone replied to the thread Hunter 34 1984 Yanmar 3GMF issue.Nice repair. Exactly what I would have done if faced with that problem except I can never remember where I left the the oxy-acetylene...
-
Jacktar replied to the thread Air vent/scuppers at port stern - what are they for?.Its a designed in ventilation system for fuel tank in the lazarette, placement of the twin tubing is critical, incoming forward short... -
Stu Jackson replied to the thread Shaft strut.Have you called Trotac in Victoria? Harbor Chandlerey in Nanaimo? or the C36 Forum? Good luck. -
Stu Jackson replied to the thread Profurl C260 furler halyard slipping.Fred's right. I was barely able to read the manual you posted and had trouble understanding your description of how it all works. Most...
-
Stu Jackson replied to the thread C22 using Bronco sport NY to Florida?.Now you see why Dave said don't open another thread.:banghead::banghead::banghead:
-
Stu Jackson replied to the thread Sailboat Recommendations?.Answer is YES. Real issue is TIRE quality. I would trailer our C22 four hours north from SF to Clear Lake, California. A friend of...
-
IPConti2025: Your question has been asked and answered over 16,000 times. If you consider the fact that many times a boat has had...
-
JamesG161 replied to the thread Gulfport Berth.I will use the Boat Repair Yard to haul out my boat and secure it. $500 my cost. Lead time is about 12 hours. Jim... PS: best harbor =... -
Do you have a thruhull for the toilet fill? If so, close it. Do you still get water in the bilge? Then it is not coming from the... -
Tally Ho replied to the thread Raw water in bilge from Jabsco.Do you have a thruhull for the toilet fill? If so, close it. Do you still get water in the bilge? Then it is not coming from the...
