All Activity
-
Jjao1972 replied to the thread Hunter 26 Cabin Floor/Ballast Tank.Mine too. I pondered not replacing the wood insert, but it needs the structure. Boatyard recommended drilling 1/4" holes and putting...
-
Jjao1972 replied to the thread Hunter 26 Cabin Floor/Ballast Tank.Thank you for responding and providing the pictures. I think the picture of the ballast tank top installation makes the most sense...
-
Just to close the loop: I installed them with the caps on the inside. My reasoning: If I ever got huge amounts of water in the cockpit... -
Don S/V ILLusion replied to the thread Sagging deck by the companionway coaming.Your thought about “the first thing you will do is resealing all deck hardware” won’t solve the problem and won’t help isolate the... -
Gene Neill replied to the thread Resources on rigging a C22 - what's what?.Congrats on the new boat! People on this forum will be happy to help all we can. Yes, raising the mast on the trailer is the way to...
-
-
Gene Neill reacted to hudson_rogue's post in the thread Resources on rigging a C22 - what's what? with
Like.
OK, so I'm the proud new owner of a 1980 swing keel C22! This is the largest boat I have owned, and I realize that I am a bit lost on... -
Gene Neill replied to the thread Large area hull deformation - Is this concerning?.You explained perfectly, KC. I just disagree with you. No disrespect. If I'm wrong, it won't be the first time. :)
-
BBenny17441 replied to the thread Are you still baffled as to how the 1 - 1+2 - 2 battery switch works?.The battery switch also provides redundancy, which is to maintain a source of power in reserve for an emergency situation. Start...
-
kloudie1 reacted to BigEasy's post in the thread Removal of sheave from this turning block in a 1984 H31 with Like.
I used an end mill in a drill press to remove the head off of the pin & used a bench vise, punch, & hammer to knock the pin out of the... -
BBenny17441 replied to the thread Are you still baffled as to how the 1 - 1+2 - 2 battery switch works?.The alternator will appreciate a battery switch that "Makes Before Breaks" You may have the need or want to change the battery in use...
-
BBenny17441 replied to the thread Yanmar 4JH80 Spares.A supply of assorted bolts, nuts, screws, and tools.
-
kappykaplan replied to the thread Removal of sheave from this turning block in a 1984 H31.It conceivable that the block was installed with Satan's glue (5200). -
BigEasy reacted to Allan12210's post in the thread Removal of sheave from this turning block in a 1984 H31 with Like.
Yes. I did that on mine. Take the cheek block off. It's no doubt glued on with sealant. A putty knife will persuade it off. That pin you... -
BigEasy replied to the thread Removal of sheave from this turning block in a 1984 H31.I used an end mill in a drill press to remove the head off of the pin & used a bench vise, punch, & hammer to knock the pin out of the...
-
Bbobmorning replied to the thread Removal of sheave from this turning block in a 1984 H31.George: Thanks, a can has been ordered! Allan: Thanks for the insight, now I have a clue of what I am up against. Bob (1984 H31...
