All Activity
-
thinwater replied to the thread Tether or Not, that is a question..A few questions they didn't ask. a. In cold weather or off-shore, the single-hander has to be very optimistic to believe he is better... -
Scott NIelsen replied to the thread Tank gauges.I replaced all tank sensors on my boat with ones similar to the ones you find on Amazon for anywhere from $29 and up that is a straight... -
Ralph, Did the same a few years ago, refusing to pay outrageous price for sailkote. BUT, I did a side by side comparison test on a... -
Scott NIelsen replied to the thread Exterior wood hand rails.I removed the wood handrails and replaced them with colored starboard (HDPE) ones with an aluminum strengthening channel routed in them...
-
Tally Ho replied to the thread Compass - Hunter 320.My old compass leaked out the fluid, and I took it home to try and refill it. Trial and error, but I finally found a decent way to... -
DTether or not, auto or manual, important questions for off shore sailing. Here's a real life experiment from John Kretschmer.
-
sailme88 reacted to rgranger's post in the thread Why you DON'T want to transit Dent Rapids (Yacultas) at the wrong time! with
Ha.
I think I dated her in high school…:yikes: -
BigEasy replied to the thread Adventures with a Beneteau faucet.Let it go Stu; not worth the worry! -
Since you mentioned windlass leak, test the leak as mentioned above, by having someone spray water from above onto the windlass. If you... -
Last big trip with a few hours to go I noticed my engine control panel no longer had power. This happened about 10 years ago and at that... -
-
rpwillia replied to the thread S1 Wheel Pilot conversion.Just a quick follow up. It looks like I can do it with minimal effort (unless you count the fiberglass structure to mount the drive...
-
-
JoeWhite replied to the thread windlass leak.Since you mentioned windlass leak, test the leak as mentioned above, by having someone spray water from above onto the windlass. If you... -
Tally Ho replied to the thread 1988 Catalina 34 Shaft length?.When I needed to replace my shaft, I pulled it out of the boat and took it to the shop, where they made new one. Greg
-
Looks good Greg. Appears you don’t have much of a tripping hazard. That is one reason I still have the line running along the rail.
-
kloudie1 reacted to Rick Webb's post in the thread Mercury 9.9 (2 stroke) hard to shift / accelerate with Like.
Sounds like the shift linkage is out of whack There is a barrel nut towards the bottom of the leg where the shift rod enters the lower...
![20260726_122213[1].jpg](/data/attachments/217/217117-9bd4e0acfcce9a528a403c52e0b6152e.jpg)
![LD1-02-big[1].jpg](/data/attachments/217/217115-b1bc2c5b95540dfc2b03d023e8679b15.jpg)