All Activity
-
Ralph Johnstone reacted to rgranger's post in the thread Why you DON'T want to transit Dent Rapids (Yacultas) at the wrong time! with
Ha.
I think I dated her in high school…:yikes: -
JoeWhite reacted to Davidasailor26's post in the thread Adventures with a Beneteau faucet with Like.
After recommissioning the water system this year I noticed my galley faucet was leaking around its body and base. It’s a single handle... -
Tally Ho replied to the thread Request for instructions to wire 1997 Hunter 376 VDO Quartz hour meter to Yanmar 2JH3E.The hours meter just needs power from the engine panel, so when the key is on. I am not sure why you showed photos of your... -
Tally Ho replied to the thread Why you DON'T want to transit Dent Rapids (Yacultas) at the wrong time!.How do we know that wasn’t AI-generated?
-
Tally Ho reacted to rgranger's post in the thread New sailor, 2 boat options, need quick advice. with Like.
One of the two options does give you the excuse to plan a 100nmi sailing adventure.:tongue:
-
Tally Ho replied to the thread Pearson 28-2 Topping lift configuration.+1 for a rigid vang or a boom kicker. My Hunter 280 had a boom kicker (2 fiberglass rods that hold up the boom). My current boat...
-
-
Spare lines? I live my lines behind at the dock when I go sailing. They are tied to the dock cleats at the just the right length... -
Ralph, Did the same a few years ago, refusing to pay outrageous price for sailkote. BUT, I did a side by side comparison test on a... -
No. This is a commonly held misconception. I've been in the tanker business, speced them out, and watched suction lines on spools fail... -
jssailem replied to the thread Disassemble ST4000 MK2 wheel unit.In 2021, I rebuilt my EV 100 Autopilot. It uses the 4000MK2 wheel assembly. I used the same Chinese electric Motor that Greg used...
-
jssailem reacted to Project_Mayhem's post in the thread Disassemble ST4000 MK2 wheel unit with Like.
I noticed the motor on my autopilot was a bit loose today. There were no obvious screws holding the two halves of the housing together...
-
The bearings are held in a very lightweight black plastic matrix, I pulled one apart to discover the plastic had broken and the bearings...
-
I just read your post a little closer…if you mean the 2 half’s of the drive wheel, they just snap together. No screws. see my video...
-
YouTube is your friend. Search on st4000 and you will get some video and see the insides.
-
I did a video on overhauling my old RM wheel pilot several years ago….maybe this will help (sorry…it is a long one) Greg
