All Activity
-
Since you have davits, I recommend lifting and securing it, with drain plug removed. Davits make it easy, or easier -
I have always had an inflatable dinghy, and they will flip in strong winds. I have personally had my dinghy flip multiple times in the...
-
Another common cause: Did you take ALL of the loops of hose off the rack before pumping? If not, the water has to rise 2 feet for every... -
Captain Larry-DH replied to the thread Storm: dinghy in or out…..Since you have davits, I recommend lifting and securing it, with drain plug removed. Davits make it easy, or easier -
I have always had an inflatable dinghy, and they will flip in strong winds. I have personally had my dinghy flip multiple times in the...
-
Rich Stidger replied to the thread Storm: dinghy in or out…..I have always had an inflatable dinghy, and they will flip in strong winds. I have personally had my dinghy flip multiple times in the... -
Good morning all, So sitting here on Block Island awaiting a storm. At anchor in 35 feet of water with 230 ft of chain / Rocna 55lb been...
-
thinwater replied to the thread Holding tank won’t empty.Another common cause: Did you take ALL of the loops of hose off the rack before pumping? If not, the water has to rise 2 feet for every... -
-
smokey73 replied to the thread 2008 Hunter 33 Rudder replacement.Al has a wealth of information and experience with these Hunter rudders. For instance, for my 1994 Hunter 40.5 the rudder shaft was... -
Jim is right on. The whole team there is outstanding. Since my stainless-steel shaft was still good, using only my existing shaft and...
-
BigEasy replied to the thread Holding tank won’t empty.Consider that dockside pump & hose has air thats causing pump to lose its prime. -
Tally Ho replied to the thread Unconventional Deck Fuel Fill Installation and Bed-It Tape.Looks like a good application. A scraper or a pocket knife will clean the excess tape around the fill port. Greg -
Allan12210 replied to the thread Holding tank won’t empty.I didn't either. All my hose clamps were tight until I tightened them again under the deck pump out fitting. Then it worked fine... -
BigEasy reacted to sailcapt340's post in the thread Unconventional Deck Fuel Fill Installation and Bed-It Tape with
Like.
Greg, it is through bolted. I also thought getting it to compress was going to be my issue as well, being a horizontal mount. But I... -
BigEasy reacted to jssailem's post in the thread Unconventional Deck Fuel Fill Installation and Bed-It Tape with Like.
This is the operative condition for this query. The Deck Fill unit will not be subjected to a liquid. A hose for LNG or Propane appears...
